Wiring a pulsafeeder chemical solution pump

Discussion in 'Water Softener Forum, problems, installation and r' started by Wellmate, Nov 11, 2010.

  1. Wellmate

    Wellmate New Member

    Messages:
    5
    Location:
    Bonney Lake WA
    I want to wire a pulsafeeder pump(220v) so it runs when the well pump is charging the pressure tank. Do i wire it to the pressure switch itself....or to the well pump control box. Any ideas. Thanks
  2. Akpsdvan

    Akpsdvan In the Trades

    Messages:
    1,495
    Location:
    Alaska
    In the past I have done it to the pressure switch with a so call pig tail, a short run from the switch with a female and then a male on the pump end so that if needed the pump can be unpluged with out turning off the well pump to undo the wires.
  3. Gary Slusser

    Gary Slusser That's all folks!

    I always used the switch to a metal receptacle box.
  4. nhmaster

    nhmaster Master Plumber

    Messages:
    3,189
    Location:
    S. Maine
    Wire it right into the pressure switch
Similar Threads: Wiring pulsafeeder
Forum Title Date
Water Softener Forum, problems, installation and r GE Smartwater GXSF23Z01 wiring diagram Today at 3:57 PM

Share This Page