Mark Olenick
I've got a good memory. It's just short ;-/
Hello all,
Thanks for the help (in advance). New DIY'r in this area looking for options if possible for a slop or floor type sink to be located in a commercial kitchen area. Located in NW PA borough that follows UPC 2009 code.
OK the problem is that the location for the cleaning / slop sink does not easily or readily lend its self to a vertical vent after the trap. To move its location would require a bunch of redesign. It is located under the steps that go to the second floor of the building. The primary issue is that in order t get to a vent we would need to run it horizontal for 10+ feet under the floor following the waste pipe which is not allowed by UPC (to my understanding).
Doing some research I came across UPC 902.2 but that seems only to apply to counter or bar sinks. Could this be used for basis of variance if slop sink direct drained to floor sink?
Hope this makes sense. Any options and guidance appreciated.
Thanks
Thanks for the help (in advance). New DIY'r in this area looking for options if possible for a slop or floor type sink to be located in a commercial kitchen area. Located in NW PA borough that follows UPC 2009 code.
OK the problem is that the location for the cleaning / slop sink does not easily or readily lend its self to a vertical vent after the trap. To move its location would require a bunch of redesign. It is located under the steps that go to the second floor of the building. The primary issue is that in order t get to a vent we would need to run it horizontal for 10+ feet under the floor following the waste pipe which is not allowed by UPC (to my understanding).
Doing some research I came across UPC 902.2 but that seems only to apply to counter or bar sinks. Could this be used for basis of variance if slop sink direct drained to floor sink?
Hope this makes sense. Any options and guidance appreciated.
Thanks