Carrud
DIY'er
The 3" drain line from the 2nd floor runs down my shower wet wall. This is cramping me with my desire to center my new shower valve which uses a Grohe GrohFlex rough-in. This new one is much bigger than the original valve.
Do I have any plausible options to, perhaps, add a couple soft bends to the 3" drain to offset it around the valve area and then bring it back to tie back into the location where it drops into the slab? Or any other idea?
The valve needs to be to the left of the that drain line.
The last pic shows approximate desired location in relation to the drain line.
Many Thanks, Clark
Do I have any plausible options to, perhaps, add a couple soft bends to the 3" drain to offset it around the valve area and then bring it back to tie back into the location where it drops into the slab? Or any other idea?
The valve needs to be to the left of the that drain line.
The last pic shows approximate desired location in relation to the drain line.
Many Thanks, Clark