Prublem
New Member
1.5cuft softener with Clack WS1 valve. Water pressure drops substantially when going through the softener. So much so that using more than one fixture results in the water exiting the fixture to almost dribble out. When the softener is in bypass mode the pressure is quite a bit higher and fine when using multiple fixtures.
Resin was replaced about 3.5 years ago with Aldex C-800 . Water source is from a well. Could the resin have gone bad already or could there be something else causing the low pressure through the softener?
Resin was replaced about 3.5 years ago with Aldex C-800 . Water source is from a well. Could the resin have gone bad already or could there be something else causing the low pressure through the softener?