well point

  1. Pkem

    PEX for Well Pump intake line?

    I have a 3/4 hp jet pump about 100 ft from a well point with 1 1/4" well pipe and a 1" polyethylene supple line to the pump. The supply line has a hole in it somewhere. I have been told I could run a 3/4" PEX line through the 1" polyethylene and it should work fine. I am concerned about over...
  2. Urban Sugarmaker

    Sandpoint well has water but I can’t pump it up

    I just installed a new 1-1/4” sand point well. I’m currently at about 20 feet down. It’s all sand to about 19 feet and then it feels like gravel. I can feel it if I turn the pipe with a pipe wrench. I initially drilled a pilot hole with 1” pvc pipe and a water pump. Worked fantastically until I...
  3. Tschmits

    Shallow Well Check valve on top of well point. Yes or no?

    I have been accumulating all parts for a hand driven shallow well. I have a 1 1/4" well point, Simmons 1721 that has inside threads at the top where a 3/4" nipple can screw in. In speaking with a neighbor with a similar well, he is down 28 feet with 8 feet of water. Everything I see on the...
  4. ApoJake

    Sand in my Sandpoint Well water

    Hi! I purchased a house that has a sandpoint well installed in ~1990. This is a direct driven point well (no casing) that is a 2" steel pipe that is only used for an underground irrigation system. When I did the washer-on-a-string method, I measured a depth of 23 feet until I hit the bottom so...
Top