fleck 7000

My water treatment bypass valve is leaking at the inlet. The supply pipe is connected to the bypass valve via a brass connector with an o-ring. The connector slips into the bypass valve and is held in place with an H clip. (It’s a Fleck 7000 unit) It leaks just below the H-clip. I’ve replaced...

Not sure what to do... I have Fleck 7000 unit. I have noticed for some time now that my water is not right but didn't have time to check on this. Finally this weekend I cleaned up brine tank, added salt and took water sample while in in bypass mode. The hardens was showing as 250. Did...

I'm looking for advice on replacing a Culligan Medalist Plus Model 30 water softener installed in the 2006 timeframe. It is not completing the regeneration cycle due to E1 and E2 errors. Not sure if it's a sticking filter pack or a weak motor. Sometimes I can get it to complete the cycle if I...