Search results

  1. Wayne Birman

    Regeneration

    I have a 255 control valve with a 460i timer assembly. After much reading, I think that regeneration is started by flow measurement and also by capacity calculations. If that is true, let's say the flow meter circuit is not working. Would the capacity circuit still cause a regeneration? It also...
  2. Wayne Birman

    Safely remove a 255 valve from tank.

    I have a 9x35 tank with a 255 valve on it. I want to remove the control valve to replace the resin in the tank. As the valve is plastic, what is the safe way to remove it? Also are there any suggestions on replacing the resin? Are there any mechanical suggestion? Thanks Wayne
  3. Wayne Birman

    Resin amount needed

    I have a 9x34 tank. How can figure how many cubit feet of resin I need?
  4. Wayne Birman

    Autotrol 255 control

    How can I tell what the part number is for the drain control assembly. I see that there are seven different part numbers. Mine does not have a ball in it, only 1000214 and 1000215 does not use the flow control ball. There is a number 2 deep in the slotted groves of the drain control. Also the...
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks