Search results

Hey all, I'm going to be installing a 35S20-8 SP pump and I'm trying to figure out what the appropriate flow inducer sleeve size would be. I see most threads on here people using a thin wall 4" PVC for a 4" pump, but I've also seen some mention of friction loss and larger sleeves for higher flow...

Hey all, I am going to be installing a SQFlex 30-SQF-160 to run a solar irrigation system on my farm. I am going to be installing a CSV with it to reduce the cycling and I'm trying to figure out the maximum pressure my pump can build to properly size my poly pipe (200psi vs 250psi), and the CSV...

Hi all, I am collecting all of my parts and fittings for a pump and tank install for my farm irrigation. My setup will be fairly standard, Pump>CSV>Tank Tee>Ball Valve> Then sent out into the yard in poly pipe. My question is would it be ok to install a 100 micron filter prior to the CSV? I...

Hi all, I made a last minute decision to go with a SQFlex pump over my SQ that I just received because I'd like my system to run PV direct. I have a CSV so I'd like to choose one of the centrifugal SQF's so I can use the cycle stop valve. My well is 200ft deep with a 27ft static level. My...

Hi all, I am building a farm and I am about to install my irrigation main lines with frost-free hydrants for my above ground distribution into timers. I have recently read about the cross connection/contamination risk the weep holes pose to water supplies. The health department doesn't require...