Search results

  1. SubnetMask

    Tightening NPT fittin in a plastic housing

    I finally got my Rheem tankless water heater installed yesterday, and after turning the water on and flushing the lines, I ended up with three drips - all from NPT fittings, and all on plastic housings. One was into the whole house filter, which since I used sharkbites on, was easy to fix -...
  2. SubnetMask

    Tankless Water Heater gas supply sizing

    Our water heater is in the process of dying. If it's just the pilot light, it'll run forever, but once the main burner kicks on, and I noticed that while the burner is on, eventually, the voltage from the thermocuple starts creeping down until it gets to 9.9mv, then after sitting there for a...
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks