Search results

Last set of pictures

The Gray is PVC Project update THE WELL IS INSTALLED AND WORKING!!!! 10/28/2017 Used 2 Stainless Steel 1-1/4" Barbed Insert x 1-1/4" Extra Long Male Adapters, combined with 1 1/4" PE NSF PIPE 80' COIL 4710 HD-125 pipe and 3 clamps on each end, 1-1/4 In. 304 Stainless Steel 90 Degree Elbow -...

Back to work after IRMA. Extension to casing done prior to IRMA and latest plumbing done post IRMA. Waiting on 1 1/4 ID Polyethylene delivery.

New pump Goulds 25GS15412C 4" Submersible Water Well Pump and motor with control box. 25 Gallons per Minute, 1-1/2 Horsepower, 3 Wire, 230 volts Old pump RED JACKET, MODEL NO 8DC, SERIAL NUMBER CA495, DATE CODE 50485, 206/230 V, 60 HZ, 3460 RPM, DAVENPORT IOWA,

The depth from cap to bottom of pump is 80 feet 4" well pipe. More progress made, last pipe ( full of holes), red jacket pump pulled, casing extension welded on, pump and control box ordered, side kick kit ordered. I did not want to put galvanized back in I'm looking for a lighter alternative

Can I use this polyethylene pipe as drop pipe? http://www.homedepot.com/p/Advanced-Drainage-Systems-1-1-4-in-x-100-ft-CTS-200-psi-NSF-Poly-Pipe-X4-125250100/205909061 I plan on using longer male barb 1 1/4 " with three clamps on pump end, longer female barb 1 1/4" with three clamps at cap...

New progress, created more working space around well pipe, cut off top of pipe, starting to pull galvanized pipe today 8/30/2017. See pictures Once pump pulled depending on old pump, get new pump, weld pipe extension, use 160 PSI Polyethylene Flexible Coil Pipe, PK1A PSIDE-KICK Kit, still...

I have a well dug in 1967 that I finally uncovered with the casing about 3 feet down which I am trying to bring back to life. My question is how do I remove the well cap with out dropping the pump into the bottom of the well or some other disaster? See attached pictures. This well is in...