Search results

Would like to know if the apollo crimp ring tool can be used with the shark bite brand rings and pex. Thanks

I ran a 1inch pvc drain pipe off a overhead pump up through attic for a washer (runs straight up from pump into attic then 45 degrees for about 4 ft before angling down to drain area. I'm concerned about freezing ofthe water left in the pipe in the attic of that 4 ft section since it can't drain...

Looking to move a washer from kitchen to garage and house is on slab. Would use a saniswift pump up to attic Andover to where the drain pipe is now for washer in kitchen. . About a 15 ft distance. Would a vent out the roof be recommended? If so location of vent? I'm thinking straight up and out...

thinking of moving washing machine to garage. House on slab. Would install some heat for garage for winter months here in New England. But if I were to run water supply lines and drain pipes through attic. Good or bad idea?

finished up with a shower install and the drain works fine but is louder than id like it to be , used 2 inch pvc , has a p trap and vent is at proper distance and vented out roof, is there any way to make it a bit quieter as it drains

Planning on connecting to 4 in cast iron , what type of coupler would be best, can I use a 4in rubber coupler , or a no hub coupler which has the metal shield around it, this would be located in a crawl space

planning layout forbath with toilet,sink and shower, connecting waste line to cast iron pipe that looks like 4 inchs, was going to use 4 in pipe to this but is that a overkill or would 3inch pipe be better

wanted to bounce this layout plan for new bath off someone ,thinking of changing the pipe from shower to toilet to 3 in and putting the cleanout closer to shower trap ,would that cause me any problems? also what kind of tee would be best at toilet , thanks any help on this would be great.