Search results

My wife and I will be moving to an independent living townhome, which will be renovated before we move in, and we have the opportunity to have additional custom upgrades done (at our cost). I told them we wanted a thermostatic valve installed in the shower (so there would be two controls, one to...

Our 1930-era house has galvanized supply pipes. Existing sink and toilet stop valves are 3/8 FIP X 3/8 OD Comp angle multi-turn. In the past I’ve rebuilt some of these by removing the old stem and replacing with the innards of a new Brasscraft multi-turn valve, leaving the existing body of the...

I'm not sure what model of toilet this is since there are no markings anywhere, but it looks like it could be original to the house built in 1930. Perhaps a Standard Modernus? At any rate, we are replacing it with a modern low-flow toilet. The tank is separate from the bowl and they're...

I recently purchased an American Standard Cadet Pro 14-inch rough-in 2-piece 1.28 GPF elongated toilet. The first one that came seemed to have a major defect near the end of the trapway, a hole about 3/4" in diameter. I'm NOT talking about the siphon jet hole in the bowl. I'm talking about if...

I know that some people think that pretty much any braided stainless steel faucet supply line that can be found at a place like Ace or Home Depot is fine. But in my research, there seem to be some real differences between different manufacturers. For example, the BrassCraft line says it uses...

Greetings, new user here. I've found the elongated Toto Ultramax II (MS604114CEFG, link below), but can't seem to find a version with the same specs except in round. When I used the Toto web site search engine I couldn't find it. Is there a round Ultramax II that is 1.28 Gpf, ADA height...