Search results

My well pump is 180 feet deep. The pump is a 3 hp 27 gpm. It used to operate the sprinklers, but now the only use for the well is to fill the pond through a bladder and and 250 feet of 1" pipe. The pump runs non stop at 28 to 30 lbs. Does the bladder make the pump work any harder ? Would I be...

I have 2 systems with both using the Hunter Icc controllers. 1 has been controlling a pump in the pond using the Hunter pump start relay. The pump start relay is wired to the common terminal and the pmv terminal as in the hunter instructions. This all works great. The 2nd system has been on city...

I have a 2 hp 27 gpm pump in the pond going to stations with 6 heads that total 18 gpm. This has been working great for 3 years. I recently took a second system off the city water supply and connected it to the pond supply. This system has lots of 1/2 and 1/4 round heads. The pressure is extreme...

I use a 3 hp pump to fill the pond, a 2 hp out of the pond for the sprinklers, and a B&W 1500 liquid control relay to start and stop the fill system. The system worked fine for about 3 years. Now the well fills the pond nonstop. The first check was the start and stop diodes and the ground wire...