Search results

We are currently planning to put in 3 12 Volt 10 Watt LED floodlights when we do our deck in the spring. My question is, what type of transformer should be used? The lights I am looking at are AC, and AC/DC. Also, would I be better off using the 120 Volt version instead? If so, where should I...

Its been a long time since i've last been here. Anyway, we recently switched out our old dryer vent hood because the old one had broken flaps. Though the new one does look nice, on the inside, there is now a gap between the vent and the wall. I'm not concerned about insulation because there is...

So we decided to change the filter today since it had been 1 year almost since we last did it. So we went down and did what we did every year. Take the panels off, Shut the switch off on the gas valve and changed out the filter. However after we completed changing the filter and the panels were...

So moving on to one of the last kitchen appliance replacements which is the dishwasher. Now, before we went to buy the new one. We checked everything over and we found something very strange. There is no breaker for the dishwasher. I checked twice and still no dishwasher breaker. Any...

I need help on the wire gauges, I picked a 18 gauge wire but I've also heard some stuff about the voltage drops. Is it okay to run 18 gauge wire for led strip lights. The run of the wire is 11 feet.

So the halogen lightbulb (g8) went out in our over the range microwave and there has been no luck finding a replacement. We called up sears and they could not find the bulb. We also noticed another strange thing. We purchased this microwave just 1 year ago and the bulb went out very quick. Say...

So we came across another issue. AMPS. There are 2A, 4A,and 6A. I am completely lost here. Could someone please help?:confused: We are doing under cabinet lighting using led strips and the power supply/transformer amps is troubling me.

So, we have decided to install under cabinet light and we picked the string LED type lighting. But we ran into an issue when we we're planning it out. Well 2 issues and in both there is an object in the way. First there is an over the range microwave and the other cabinet is after the unit...

Well its happening once again but now its worse. The valves for my washing machine are leaking. But I noticed they look they are threaded/screwed on to the pipe. However there is a soldered threaded piece soldered to the copper pipe. Can these be unscrewed? Or soldered off? Could someone please...