Search results

I think these are rooty tampons - o_O. I am sure of the tampons but can anyone confirm the root part? It does look fiberish but really thin. I pulled out these two bunches with my older drain snake with the spade bit. I am now going to rental place to get a self feeding drain snake with a...

I own an older three family house that has these symptoms which is essentially gurgling in 2nd floor tub and basement tub/shower No complaints yet from third floor. More details are below. I am trying to determine if I start my investigation in the basement or upstairs (roof). Is there a...

I would like to replace the trim and valves for this shower faucet. The trim is marked ACE, I assume from ACE hardware but I don't know if this started life as a ACE branded faucet or this is some replacement trim. I can pull the valve if needed to I.D. but this is not a easy job as it is in...

I have a house in an area that uses a water tower for pressure and pressure at lower floor is 20-22 - psi. I wanted to bring the pressure up to a more normal 50-60 so my tub doesn't take 25 minutes to fill. I started with a scala2 and it worked well enough with high demand but with low...

I have a closet flange about 15 inches from the main stack. See picture. I want to move the toilet a few inches down the joist cavity toward the camera and I want to add a shower drain about 30" down the joist cavity away from the camera. Is it suitable to use a double combination wye with...

Any idea what type of faucet this is? I thought it was a delta 600 or similar. My original problem was handle broken and trim scratched. I bought a delta 600 kit thinking I would use the handle and and the trim and save the internal parts from a later day The handle goes up/down/left...

I am an electrician replacing a air handler in a really small closet. Problem is there is a 6" single wall galvanized steel exhaust duct in my way. I need to temporally remove one section to get the air handler out. Problem is the pipe comes through the floor and goes up to the floor...