Search results

I'm installing an IKEA sink. Can I install a slip joint (1 1/4 PVC to 1 1/2" ABS) in a horizontal position or must be vertical? thanks

Thank You Another question: The faucet is coming with a S-shape union. Do I need that? Is a reducer from 1/2 to 3/4. I prefer to use a 3/4 pipe directly from the wall to faucet.

I have to install a Grohtherm 2000 bathtub faucet. Is a new installation. At what height from bathtub should be installed? Than you. Here you have a picture of the product:

Thank you! I have access from above only.

Hello All, I have to install an acrylic bathtub. What brand of silicone should I use? How tide to tread the drain basket to the plastic pipe? What is the proper sequence: installing the p trap and drain pipe first and last the drain basket and overflow or first the pipe to the tub and...

Thank you for suggestion. To make everything more complicated there is no space on side walls: Right is a corner and left a storage cabinet. I have Belanger concealed laundry faucet. Can I install the valves in next room? Is a storage area.

So a plumber used an iron reducer for a copper pipe?

I will install my laundry set in a small room. The units will be stacked against a wall ~5'. On one side I will have a narrow cabinet. Question: where to install the hot/cold water valve? What is the best position for this setup? Thanks, M.

For some strange reason I have a venting line above a window in my basement. There is a 1" 1/2 vent on the left side and 2" on the right side that connects above the window and goes up above the roof. May I use a double 1/4 bend upside down for this? The space is tight for a sanitary T + 90...

Is there a specific position for a hammer arrester? Can be installed in a horizontal position?

This is a basement bathroom and above is there is a kitchen. Size ~14' X 5'. It may look strange but I want to have a backflow valve for the basement. Most probable we will install a floating vanity, so the valve is under the washer/dryer. Toilet is vented trough sink or bath tube vent. Few...

What's the best way to hide a back flow valve in a bathroom?

Thank you. I will come with a better plan in few days. One question: Do you think is a good idea to move the backflow downstream after the two lines are joined? In this way I can have this valve in the furnace room. Previously the valve was sticking out of the floor for 1/2" under the vanity.

Thank you for your input. The bath will have a separate vent close to the P-trap and the toilet will be wet vented trough sink drain (2"). Actually both vertical pipes are connected together and vented. Question is: Where to connect the bath drain? To the sink drain (picture) or on the left...

Thank you for your answer.

We are remodeling a '90 bathroom in a '60 house. The image shows how the pipes where setup before. The first step was to move the backup valve to another location. The next step is to replace CI with ABS and to lower bath tub drain into the slab. Previously tub drain was above floor. We are...

My vertical drain is 1 1/2. There is a dishwasher + kitchen sink on the first floor and a washing machine in the basement connected trough a back flow valve after the p-trap. I newer used both washing machines at the same time. Is this diameter fine for both machines at the same time or I need...

Can you give me some suggestion where to start? What to replace?

Hello, This is a basement full bathroom. What I want to do is just moving my laundry to another wall but after drywall and floor removal, a beauty was revealed. I am talking about drains only. For the last 1-2 years toilet was gurgling if the sink was used for more than few minutes. bath...