Search results

I am building a tile shower in my basement. I bought a threaded drain and installed it into the pvc that the original builder left. The threaded drain is one where the top part screws up and down so that you can customize it according to the hight of the tile. I have laid the pre-slope, the...

Can anyone tell me what the symtoms would be if the cold feed line to the water heater were connected to the hot side of the water heater and the hot line serving the fixtures connected to the cold side of the water heater?

My natural gas hot water heater (State Select - model pr650NBRT) has been inconsistent for a couple of years now - but adequate. Today it is now providing almost no hot water. What can I check? The temerature control setting is on high. The flame is working. It comes on after running the...

I am installing an American Standard shower. The instructions say to turn the valves to the "off position". "Off is not labeled anywhere on the hardware. Is there a standard way to identify "off positoin"? As I turn the valve, I can barely feel a slight click at a certain point. Is this it...

I am finishing my basement. I have rough in drainage for a full bath. I need to cut into the existing water supply for shower, toilet and sink. The whole house is currently supplied with Pex lines. I want to "tie in" to the Pex with Watts Quick-Connect fittings and continue with Pex for the...