Search results

  1. JEP

    1/2" pex to 1/4" copper for ice maker

    I need to install an ice maker. The plumbing in the house is all pex. I have easy access to a 1/2" pex pipe, but have some restrictions as I cannot get a crimping tool into the tight area available to me. I'm guessing that a saddle valve and pex would be a mistake, right. I read a few...
  2. JEP

    bypass shower doors

    I'm not sure this is the right place in the forum for this but here goes. I'm installing bypass shower doors on a standard 5' tub. The upper and lower tracks need to be cut. Any tricks, or ideas on how to get real nice straight cuts on these? Is there something better to use that a hacksaw...
  3. JEP

    Steel of Acrylic Tub

    I will be replacing the current steel bathtub in my bathroom. Cast iron is not an option for a few reasons cost etc. My choices are Steel or Acrylic. Is one better than the other? What are the pros and cons? I know both should be bedded in mortar. What kind of mortar is the best to use...
Top
✖
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks