Recent content by Enosez

Jadnashua, I sent you a "conversation". Hopefully you got it.

The boiler in question is a slant fin VSPH-180 I checked the install manual and could not find anything that referenced it but I'm pretty sure its referenced in code which I am not familiar with.

Does anyone know how close or how far away from a b-vent chimney (direct vent side wall) a bathroom exhaust vent can be to it? What about a fresh air vent (make up air) for the boiler room. All would be at the same height from the ground. Thanking in advance.

Thank you

Anybody??

Anybody? Just to clarify, we are NOT touching the electrical. Pavers and pool piping have been replaced. Electrical is the way it was when it was installed.

Question: Working on a job site and the pool is being converted to chlorine generation via salt. This is NOT a new install. Pool water piping was being changed and converted to chlorine generation. A bond wire was run completely around the pool attaching to all corners of the steel wall pool...

Thanks Stuff. I swear when I first saw your reply , I didnt see it as it is now. All I saw was "The spec sheets have most of what you want." So my apologies for asking the same twice. All is done except for the mini-condensate pump. That is stumping me. Any experience or thoughts with that?

Thanks Stuff. I assumed that. Would you know if the indoor unit gets its power from the condenser. Also the communication cable between the two. Does that have to be 14 as well?

Yes its done. The units are installed, vac'd and charged. Now its only time for electrical hookup.

I'll start by saying that Ive been out of the trades for a while, well before split units became popular so my experience with them is limited. I am installing a Samsung AR18KSFPDWQX in my basement. I have a few questions when it comes to the wiring, the instructions on the Samsung are not...

Thank you

What is the ponpc connection? Do you mean at the air scoop inline with the expansion tank?

my question is can I remove the 3/4 plug located in the pic and use it to install the water feed and pressure reducer for the boiler?

The user....wink wink. There was an issue with the washer. It stopped mid cycle and wouldnt rinse. Since the machine was under warranty, they came out and said it was the box not the washer. I recalibrated the box and it seems to be working now. Howeowner now wants the box removed saying its...