Waltec / Flotrol diverter problem

Discussion in 'Shower & bathtub Forum & Blog' started by Microfiche, Jul 4, 2011.

  1. Microfiche

    Microfiche New Member

    Messages:
    3
    Location:
    Winnipeg, MB
    I am trying to keep my old shower diverter working until I can redo the whole shower with a new surround and anti-scald valve, so I picked up a replacement cartridge.
    The old one was almost impossible to move in and out and did not seal well. I installed the new one, and it worked OK, although a little stiff. After a few weeks, I pretty much had to turn the water off and bang it hard with my fist to divert water back to the tub spout. I picked up a new one again, pulled the old one out and tried to clean the valve out with some Scotchpad and 400 grit wet sandpaper, thinking perhaps there was some buildup there. Greased it up and put in the new diverter, but it is still tight and hard to operate. Anyone have any ideas? Waltec Diverter Assembly For Flotrol Concealed Tub & Showers (1970-73) O.E.M. T25168

    [​IMG]
Similar Threads: Waltec Flotrol
Forum Title Date
Shower & bathtub Forum & Blog Replacing Waltec Shower Cartridge Apr 26, 2009
Shower & bathtub Forum & Blog "Waltec 12" Mar 23, 2009

Share This Page