Toto bowl not refilling fully after flushing

Discussion in 'Toilet Forum discussions' started by shungdog, Mar 3, 2010.

  1. shungdog

    shungdog New Member

    Messages:
    1
    Location:
    West Seattle
    My Toto with GMax Flushing System is not refilling the bowl fully after each flush. Appears to otherwise work properly - no leaking, tank refills fully, flushing is adequate. Had to replace flapper valve because the original one had broken through at the chain attachment point but new flapper seems to work same as old one.

    So question is: Is it possible to adjust the delay the amount of time before the flapper closes to allow more water to drain into the bowl? Could there be a problem with the fill valve? I don't really think so and it seems like this should be a simple problem but having trouble figuring it out. Have played with adjusting chain length and handle lever but can't figure it out. Any advice would be greatly appreciated.

    Thanks in advance!

    rc
  2. jadnashua

    jadnashua Retired Defense Industry Engineer xxx

    Messages:
    21,937
    Location:
    New England
    Make sure that the hose to the overflow tube is still pointed into the tube. Is this the original fill valve? Did you use a Toto approved flapper? Did you get the right type?

    [​IMG]
    Last edited by a moderator: Mar 3, 2010
  3. Terry

    Terry Administrator Staff Member

    Messages:
    14,929
    Location:
    Bothell, Washington
    The black tube refills the bowl.

    [​IMG]
Similar Threads: Toto bowl
Forum Title Date
Toilet Forum discussions Best Toto Bowl Cleaning Ultramax II SanaGloss, UltraMax 1.6, or Promenade w/sanagloss May 21, 2014
Toilet Forum discussions Will Toto Drake 1.6 tank fit any other bowl? May 1, 2014
Toilet Forum discussions Can I put an toto aqua tank on a vespin bowl? Apr 13, 2014
Toilet Forum discussions Defective Bowl? on Toto Drake II Mar 25, 2014
Toilet Forum discussions Toto Drake - Round Bowl VS. Elongated Bowl Jan 19, 2014

Share This Page