tile on wall

Discussion in 'Remodel Forum & Blog' started by kkreimann, Apr 30, 2005.

  1. kkreimann

    kkreimann New Member

    Messages:
    5
    i have an adobe house so my master bathroom has tile on an exterior wall. there is an existing layer of concrete that i removed the tile from. the problem is it left some mortar. this makes my wall not flat for new tile install. what can i do, i have tried scraping and it doesnt work. can i belt sand? or is skim coating with mortar the only option?
  2. jadnashua

    jadnashua Retired Defense Industry Engineer xxx

    Messages:
    21,820
    Location:
    New England
    You'll probably get some ideas here, but I'd try www.johnbridge.com I think you'll get more ideas faster. Trying to flatten the wall is possible, but may not be necessary, except to make it easier to set the tile evenly. You could probably chip it off, but it may take out chunks. Somebody over there has probably done this and will have some ideas. Unlike floor tile where it should have 100% coverage, that isn't as important (still desireable) on a wall. My unprofessional opinion.
  3. kkreimann

    kkreimann New Member

    Messages:
    5
    thanks for the website it was a big help!
Similar Threads: tile wall
Forum Title Date
Remodel Forum & Blog Tile behind wall hung vanity? Jun 11, 2013
Remodel Forum & Blog Insulating R5 'Penitentairy tile' walls Nov 20, 2012
Remodel Forum & Blog Regrouting tile bathroom wall Oct 7, 2011
Remodel Forum & Blog what to set first - floor stone or wall tile?? Dec 28, 2007
Remodel Forum & Blog best tile to concrete cement Jul 1, 2014

Share This Page