bathroom sink plumbing

Discussion in 'Plumbing Forum, Professional & DIY Advice' started by NYCremodel, Oct 24, 2012.

  1. NYCremodel

    NYCremodel New Member

    Joined:
    Mar 14, 2008
    Location:
    New York, NY
    Originally plumber installed supply lines a few inches higher than drain. (and few inches wider) But then realized that the drain was too low to fit inside vanity. They raised the height of just the drain rough-in and the supply rough-in are same height they were. So the question is... is it ok that the drain and the supply lines are the same height (from floor)? And if so is this going to pose a problem of them getting the drain rough-in to the bottom of the sink which horizontally will not be directly above the drain rough-in? (See rough sketch attached) vanity.jpg

    Thanks,
    Mark
     
  2. Terry

    Terry Administrator Staff Member

    Joined:
    Aug 17, 2004
    Occupation:
    Plumber
    Location:
    Bothell, Washington
    The water supply lines can come from almost anywhere. Sometimes they even come from the side.
     
  3. Sponsor

    Sponsor Paid Advertisement

     
Similar Threads: bathroom sink
Forum Title Date
Plumbing Forum, Professional & DIY Advice Single to Double Bathroom Sink with 1.5" drain/vent Today at 9:10 AM
Plumbing Forum, Professional & DIY Advice Drain line: going from 1 bathroom sink to 2 Yesterday at 6:28 AM
Plumbing Forum, Professional & DIY Advice Two Bathroom Sinks Back-To-Back. What Double Fitting To Use On Horizontal Drain? Dec 8, 2015
Plumbing Forum, Professional & DIY Advice Bathroom sink started draining slowly Dec 6, 2015
Plumbing Forum, Professional & DIY Advice Major issues fitting new drain to bathroom sink. Nov 15, 2015

Share This Page