Search results

I just purchased a porcelain sink that was made for a single hole faucet mounting. Is it possible using a diamond core bit to drill two additional holes for a 4" spread faucet (like you can drill a hole in porcelain tile)? Or will the vanity most likely break/shatter? Jim p.s..... I am...

Still looking for a vanity faucet... single hole mount, brushed nickel, not a vessel sink. Seeing several different brands, but I don't know anything about them. Any opinions on which to buy, which to avoid??? Some of the brands I have seen... but please don't limit input to just these...

I remember my dad using a small submersible pump to help a neighbor who's window well would fill with water, and then flood the basement. This pump was about the size of a large can of baked beans (how's that for technical??? about 6" high and about 5" in diameter). I don't remember having...

Wife saw a bathroom faucet at IKEA. I'm concerned about quality, and availability of replacement parts. (With the low price tag, I suspect this isn't the faucet I want.) Anyone with input? Experience? Alternative brand w/ similar look? http://www.ikea.com/us/en/catalog/products/60101789...

I recently had a new driveway poured: 4" thick, reinforcing wire, saw cut, with a 6" curb along one side. Drive is fairly level, with a drop of about 5" in 20'. The new curb is half the height of the old curb that was removed. My problem is that the neighbor's yard is about 2' higher than my...

This is totally a non-important question; just curious...:confused: When I open only the hot water side of any of my faucets, the sound of the water exiting the faucet changes when the water gets warm (it is only a matter of seconds from first turning the faucet on until water gets warm...

I have read several threads that reference "soffit vents" for bathroom exhaust fans. I am installing a new light/fan combination, and would like to do it right. The bathroom had been vented directly into the attic, above the insulation. I don't see any evidence of moisture condensation or damage...

I had piggy-backed this on another thread, but no response yet....:( Should I use any type of "lubricant" when tightening down the internal nut on the rubber "donut" or ring in the Oatey no caulk drain? (I did make sure to tighten the nut on the bottom and use thread sealer to help make...

I have just finished "dry fitting" my new pvc plumbing for a total bathroom remodel. The toilet flange is too high for my anticipated finished tile floor level, by about 1". The current dryfit has the correct slope. (I will sister new joists next to the ones that have been "notched" to...