Search results

I am installing new kohler shower doors into my existing tub/shower surround. The instructions call for anchoring the side frame to the wall via #8-1.5" screw and anchors. This in fine BUT I must go through my surround ( about 2-3 inches, hollow) before I get to the drywall. I'm thinking of...

First off, forgive me if my terminology is off. OK, I had an original "gravity" boiler system. The old expansion tank was way up in the attic. The tank/leftover pipes are higher than any radiator. I'm concerned about the air trapped in these pipes without a radiator to bleed. Do I simply insert...

I can't seem to find one anywhere, even online. There are a few on ****, but I don't want to wait 5 days for the auction...

My install is about done (with a bit of elec to go). I am now preparing to fill er up. I have: Weil CGa boiler 1 zone, Taco 4900 Series Air Seperator on supply side Taco 1/8" Hy-Vent on boiler Boiler drain valve Watts ET Expansion Tank Taco Cartridge Style Pressure Reducing Valve...

I have: new WeilMClain CGa standing pilot boiler. two (2) 007 Taco circulators (supply & return sides) a Taco Single Zone Switching Relay (SR501) for 2nd circulator Tekmar 256 single stage boiler control Thermostat (boiler demand???) one (1) 24v transformer I just can't seem to get the wiring...

How important is it? I'm installing a new boiler with existing black pipe. I will have brass valves (3) and brass taco air separator. Are the dielectric unions necessary? Is this a BIG deal? Thanks, XM

How important is it? I'm installing a new boiler with existing black pipe. I will have brass valves (3) and brass taco air separator. Are the dielectric unions necessary? Is this a BIG deal? Thanks, XM