Recent content by rjgogo

So I have a Freedom 90 and getting the 3 blinks which says it is a pressure switch issue. Here is what I have done so far. Vacuumed the intake and output pipes to make sure there are no debris in the pipe. I also ran an endoscope in as fare as I could and there was nothing I could find...

It seems my peroxide injector has become clogged and is causing low water pressure in the house. I have checked everything else and the water pressure is fine outside where it is not connected to the filtration. I plan to take apart the injection part but would like a spare in case I break it. I...

I'm pretty sure it is some type of relay, about 99% sure. I don't think they would put line voltage in the sensor. My guess is it senses a closed or open state in the sensor I cleaned, and then calls for power to the pump given the status. Thank you again for the link to the video. My...

Thanks to Bannerman's video link I have repaired the issue. The switch was all guncked up with iron deposits. Let it soak in CLR for a half an hour and hit it with a tooth brush and rinsed it off. Without the help I would have had no way to know how to disassemble the switch. Pretty easy...

Thanks all for you assistance, especially the video to take apart the switch. I had never seen one of those prior to having this installed. I figured out a way to drain the system to install the water heater, I will figure it out again, as I don't recall. Unfortunately the only drain is at...

There is not one there. Only by the pressure take which is in the crawlspace, This is in an addition that was put in at some point by one of the previous owners. But I can drain it there. and probably the rest of the house.

Thanks, I wish they had of installed a shut off there, Looks like I can take it apart though it will be messy. We did have an issue when the well ran dry and it tried to regen with no water. When I found out I unplugged everything until we got the new well drilled and functioning.

Does this help

I have a hydrogen peroxide injector solution to deal with rotten egg water odor and am having a problem. The pump used to only run when a faucet was calling for water. Now it does not shut off even when the all faucets are closed. I have manually turned it off. We did have a situation where...

The pop up lever in the tail piece broke, it is the shaft with the ball towards the end. It broke at the ball. I looked at the kits at the box stores and the ball in those kits is bigger and won't work. I have looked high and low trying to find a replacement and I have come up short. I'm in...

Thanks for the idea and it looks like a good one but there is nothing to thread into the Grohe cartrige. The lever installs through a hole. No threaded part in the cartridge

I have a leaking cartridge in this shower valve and for the life of me I can't figure out how to remove it so it can be repaired or replaced. It is fairly old but o ring kits and even a cartridge are available. I have taken the cap off, the lever and the big nut has been unscrewed and...