Oregon97
New Member
- Messages
- 4
- Reaction score
- 0
- Points
- 0
Hi All,
I just replaced my motor on my jacuzzi pump. Installed a low pressure cut-off switch this go round to save the motor if my holding tank runs dry as it has in the past.
I've just got everything going tonight and can't get above 30 psi? Any suggestions on what to try next? Could it be the pump is toast? I can get to 30psi and it holds, so there are no leaks. But I can't get to the desired 60psi that I want.
Any help would be greatly appreciated.
Also, there is a brass fitting that is between the pump and the holding tank line. Is that a back pressure valve? Could that be a issue?
Thanks
I just replaced my motor on my jacuzzi pump. Installed a low pressure cut-off switch this go round to save the motor if my holding tank runs dry as it has in the past.
I've just got everything going tonight and can't get above 30 psi? Any suggestions on what to try next? Could it be the pump is toast? I can get to 30psi and it holds, so there are no leaks. But I can't get to the desired 60psi that I want.
Any help would be greatly appreciated.
Also, there is a brass fitting that is between the pump and the holding tank line. Is that a back pressure valve? Could that be a issue?
Thanks