sharkbites

  1. ELY_M

    What size of sharkbite should I use on 10mm copper pipes in old mobile trailer?

    I know sharkbite fittings and valves come in inches for sizes. I am not sure what size would fit 10mm OD old copper pipes. I need to set up new water lines with new valves under kitchen sink. the copper pipes are 10mm OD according to the measurement caliper I have. The mobile home was...
  2. not_plumber

    Third hot water compression fitting's center keeps cracking

    There's a 30 foot run of 1/2" copper hot water pipe that was cut where a compression fitting was installed. I replaced this hot water fitting 3 times with a new one of the same type that was on there that had gotten old and rubber seals dryrotted away which means it was leaking badly. The new...
  3. CubGirl

    The PEX toilet riser was cut

    the crazy plumber cut the pex riser to the toilet. will one of those shark bite things fix this? you can see just a little bit of the riser in the pic. i'm hoping i have enough PEX that the repair is either under or above the subfloor. i don't want the repair job to be at the subfloor where...
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks