autotrol

I'm looking at improving my Softener to make it more efficient based on the actual conditions. I'm currently using a Autotrol 960 ProSoft Control. I know it's obsolete but it's still working great with no issues. The question I have is about calculating the Brine Draw. The manual includes a...

I have an Autotrol 255 system and it was working well until I changed out the resin lately and since then I am having trouble drawing brine. At the beginning of the brine draw the water in the air check valve goes down and the valve closes. I can get it to work if I go to the refill stage for a...

I have an autotrol valve installed right now with inlet on the left side. I am not sure if that is correct but the valve broke anyway. This system was working good softening the water. My main shut off and water heater are on the left side, if I face the softener. I want to install this fleck...

Reaching out for help on solutions to the following problem and suggestions on correct cycle time and programming. PROBLEM: Softener does a regen, shows 1120 gal capacity, water is used only down to 740 and it regens again. MY SYSTEM: Softener 268-762-200-1252 Autotrol, 2 cu ft SST60 resin...