Search results

The deck plate is hollow on the bottom and included spongy foam gasket (which is pre-attached) is recessed into it. Not only does it not extend all the way to the edge of the plate, it's also not thick enough to make enough contact with the surface to give it enough grip, especially on the slick...

I installed a Moen bathroom faucet over the weekend. It's a single-hole faucet installed in a three-hole sink, so I am using the provided escutcheon plate to cover the other two holes. The problem is the gasket included with the plate is pretty insubstantial. It is very thin black foam and...

Yeah, I looked a little into that one. The bolt access with the L-shaped things did not look good. Also I think it is 1.28gpf max.

Has anyone had any experience with Swiss Madison toilets? Specifically the SM-1T127 model. I need a 10" and prefer dual-flush (with 1.6gpf). The prices I have seen are about half the MSRP (around $300), so it fits my budget. But I can't find any reviews. I found reviews on Home Depot of the 12"...

Can anyone recommend a good one-piece dual-flush toilet for 10" rough-in for a reasonable price ($350 or less)? They seem to be almost non-existent, at least from the major manufacturers. So far I have found only one...

I am remodeling a bathroom in my basement, the home is about 33 years old and I am the second owner. Before removing the existing toilet I measured from wall to toilet floor bolt centers and it was about 12 inches. Based on that I purchased a new toilet for a 12-inch rough-in. When I removed...