Search results

Hi, My Shop is fed from my home which is about a 100 FT Run of Black Plastic pipe I believe it's around 1 Inch ID, My issue is when I ran it I was not able to get it under ground easily from where it comes out of my home to where it goes under ground is 5 to 6 Feet, This part of the pipe is...

Hi Mine will make a similar sound but only for a few seconds every once in a while, What and how should I try to lube it?

Yes I set Pre charge to 38 PSI, Is the added pressure that much harder on the supply lines?

Hi, I turned up my well pressure switch a few years ago from 30/50 to 40/60 but my switch standoff pipe and switch were clogged and I did not know until I cleaned it two weeks ago. My pressure now is very good. I am just wondering if I leave it at a true 40/60 that it is now is it a lot harder...

I am not sure if I would draw the pressure down lower then the pump can supply, What pressure does it trip it at?

What are the difference between these Square D Switches, One is a 40/60 the other 2 are 30/50 I think one of them has adjustable pressure spreads and the others are fixed? Does it matter which I get as they are adjustable between 30/50 and 40/60...

I think i would keep it water, If I was ever to shut off heat totally off Id drain it down. I was thinking of putting race deck down.

I have a Drain to use, I have a few different to choose from How hot do you usually want the water for a system like this? Mini Split Would have been nice when I first did this build I am not sure now if it would be or not.

When I poured the slab I did put 2.5 EPS around the outside of the walls, The only wall that does not have it is the front wall which is 2 ft high and 6 foot wide on each side of the door. The Fujitsu 9RLS3H Seems like a nice set up, But I would still have cold floors, I can feel the cold...

I am in the Catskills Mountains of NY, I have Insulation and a vapor barrier under the slab, I have 4 foot cement walls which are probably 3/4 under ground on the three sides. We use LP here.

I'll run the Calcs as soon as I get a second. The Room upstairs has a door to the out side and 4 windows, the down stairs has a man door, garage door ( highest R Value door I could buy ) and 3 windows, all windows are new Energy windows. The walls are all a full actual 2x6 with the correct...

Hi, My garage is 28x28x10 first floor and second floor is 28x28x8. Right now I have on the first floor a Big Max 80 K hanging unit ( I know it is over sized ). The second floor has a ventless propane fireplace which I only turn on if I am going to be in the man cave. There are stairs with a door...

I flush mine every year for the last 10 Years, I used white vinegar the first 8 years and haymaker the last two years. I flushed mine last sunday and when I was done I had a leak out of the heat exchanger. Navien was great and sent out a new one over night. I will still flush mine yearly but...

Thank you guys for the replies, Reach you are saying I could put the motor leads on the outside terminals and the power leads on the inside and it would still work? Not that I am going to just trying to learn. Thanks

Okay so mine is right? I could switch the two power wires ( White and black from breaker box ) with each other and also switch the two motor wires ( White and Black center wires ) with each other and it would be fine? Why do the pictures I took from the net have black with black and white with...

Hi, Today I decided to clean out the tube that the Well pressure switch is connected to ( Completely clogged not sure how it was working ) and I cleaned up the switch. I have a Sta - Rite SK 2 switch which I adjusted to be a 40/60. I also have a 1/2 HP 230 Volt well pump. Now I have had no...