Search results

So the toilet pipe fell off during a reno, wasn't soldered well at all to begin with, there is almost no coverage and half the pipe is pitted from the flux inside the joint. Realistic to solder this very loose fitting 3" pipe? Rubber coupling a reasonable way to fix this?

I have a tub and shower only, is it best to get a single function trim and use a spout with a diverter or get a dual function trim and diverterless spout? I'm used to the diverter on the spout with the likes of posi temp, i am missing out? item is question...

This clamp makes noise when this hot pipe expands/contracts what's the proper way to fix it? I don't get it, there are two nails and and a clamp, this should be foolproof since it's inside a wall and yet it makes noise.

Am i going to have any problems with this setup? If so, is there any other way of doing this besides lowering the drain at the wall? The drain is sloped properly but it worries me that the vertical piece is so short. Don't mind the rubber piece, it will get soldered eventually.

So i have this 60 year old seal that has completely disintegrated. What's the right type of seal to put in there? This one has the perfect internal diameter but i'm concerned it might be too thick...

pulled out an old steel tub, it was sitting on two 10" pieces of 2x4, is that a good way to install the new one?

Hi guys, I am renovating the bathroom, contemplating whether it's worth it to replace the lead toilet drain or not, money is tight and I'm getting quotes of 600+. it has never given me any problems and other than peace of mind I don't see much reason to do it. the existing flange was of the...