Search results

So after countless hours of troubleshooting I think we were able to fix it. It actually appears the problem was with the wiring going out from the fan coil to the heat pump. Everything seemed to be ok when the heat pump was out of the equation. Since it was an 18/5 wire going out to the heat...

So I went and found that little board you had mentioned. Pulled it out cleaned the contacts as best I could. Also checked the 2 resistors and they appear to be within the tolerance range. Thermostat is still displaying the faults. Noticed something last night. The thermostat has comfort...

Thanks for the reply. I actually have one of those newer Infinity Touch models. It's been pretty good so far. Nice to look at as well :). As for the fault codes; the system has been running pretty good for the past 4 hours. When the fault codes come back (pretty sure they will), i'll go ahead...

At our home we've been having an on and off issue in regards to our Carrier fan coil and Bryant Multistage Heat pump. It seems like at random times throughout the year, the system would work fine until we start getting the dreaded 178 indoor/179 outdoor communication fault errors. The wiring is...

Bought a house about a year ago that came with a Clack WS1 water softener. Noticed right away that the water meter function does not work. It always sits at 1363 gallons left. Since the meter doesnt work I have to sit the softener to recharge at intervals which is not effecient. When water is...

Yes it is a TDS meter. Should I not be using this to test the water hardness? Tried from several different sinks in the house and after running for a few minutes get readings in the 400's

Ok this makes sense. So I have 2 1/2 baths. And there's 4 people living in the house (2 adults, 2 children). From the site Reach provided (http://www.qualitywaterassociates.com/sizing.php) It seems like I should have something closer to the 2-2.5 cu range. So i'm going to say you're right...

I guess another question I have is what type of salt lbs settings should I set the softener to? So it appears to be a 32000 grain tank. After running a test on my water it appears to be a hardness of about 25-26. I think currently the softener is set to about 9.5 lbs salt.

Ok so I did a little guesstimation (i'll have to take the shroud off later) with the shroud on and the tank appears to be 48 in. high which matches up with e 32,000 grain tank. After checking through the valve settings I think thats what the capacity was set to as well.

Thanks so much I think that one is it. Here's a picture of the barcode stickers I was able to find on the valve. Is there any way I can find out the resin tank capacity other then calling a water specialist to come and check for me?

So I just bought a house with a pre-installed water softener. Its been about a week now and I finally had a chance to take a look at the softener. Lo and behold there are no model numbers are anything of the sort that allow me to identify what model I have. I did some searching on google and...