Search results

Yes I read some of the water softener thread repiy posts. I have hard water coming into my house. I also have an electric storage hot water heater. My softener just up and quit have I am thinking I should do without it. Can someone out there help tell if the softener would help the...

Does your ceiling come with that pop corn finish. Switch boxes are rate in cubic inches. A # 14 wire is rated at 2.00 C.I. A # 12 wire is rated at 2.25 C.I. The switch is 2 x the C.I. rating of one individual conductor. This food for thought is your trying to do this under the...

freezer on GFCI One begs the question, why not use a cord set with a grounding conductor, plug into a grounded receptacle. Was not the grounding conductor inside the cord set place there to shunt the leakage current away from the freezer metal parts that would come in contact with the home...

Blah 204, I read your post wrong. Did you run a three wire cable to the ceiling fan with light kit. That goes, black, red, white, bare copper ground. Are you sure the dimmer which control's the ceiling fan light kit, is wired to the correct wire, that feed the lights. It easy to get cross...

hj I agee with you, about "false trips". But if the DIY was to hire a license sparky in his area to do this work, he would have to install to the current electrical being enforce in this DIY area. The DIY could change out the GFCI after the sparky leaves.

Home Depot floor finish Thanks jimbo for your reply to my question.

He could install a GFCI receptacle for the washer. But depending on the code, its not a legal requirement.

Speedy Petey answer was very good. I would just add, If the amored cable is not a good grounding conductor, install GFCI duplex receptacles. This is an opinion on mine. Replacing the old BX cable is better, if you have the funds to do this.??

If you can, I would suggest, using #14 for just the light circuit, underneath you upper cabinets, if you don't go low voltage. If much easier to work with. Refrigerator on its own individual circuit. I your local code doesn't require AFCI or GFCI breaker is the kitchen area. than don't use...

The breaker may be the cause of your problem. Old breaker, don't handle the inrush current well, check to see if a HACR type should work. Read the motor name plate, and use the breaker they call for.

Did you get any instruction on how to installed this luminaire. If so following the instructions. The other's have given you good advice. True, not all luminaires need to attach to a fixture box. Work safe, and good luck with this project.

You don't use slide dimmer for ceiling/paddle fans, their used for lighting. Buy a control that made for ceiling/paddle fan. Ask a store clerk for help.

I was visiting the local Home Depot store in my state, and was wonder what they used over the concert floor. to seal it. Does anyone on this forum know? THANKS!

Homeline breaker in a G.E. panel rmelo99 to your reply to my thread Didn't know, that why I put this thread in. Thanks for your answer. Now I know they will not work.

Can and would you use QO SD Homeline circuit breaker in a G.E. panel. The panel has a 100 amp. main disconnect. The breakers in the G.E. panel are only going to be temporary, during the contruction stage. After which, a new panel will be installed in a new location, with the...

voltage drop calculactor To: 220/221 Me like the "Voltage Drop Calculactor" you posted. Where its saids: "enter 1-way circuit length in feet" Is it adding another 100 feet, if the one-way circuit length is 100 ft. ? I believe it would. Thanks.

Why did the Test GFCI receptacle trip I write this now, because I felt I didn't write my original Thread very well. I left out something. I believe it was, that Pete was wiring new circuits into the house existing panel box. The second thing left out, was there were two circuits...

If the receptacles set back to far? You check with your local electrical supply house. See if they sell the Arlington, brand box extentions. I used, then, they have a lip that extends all the way around the outlet openning. Home Depot also see box extentions, and they come in...

Single conductor used for grounding two wire receptacles Correct if I am wrong, but didn't the old code books allow for such a thing. That you could connect to the nearest water pipe, (not plastic). Then it change to the grounding conductor had to be run all the way back to the...

re-wire my house? pensfan84, I can't speak for the rest of the guys who will come on line and reply to your thread. First I would, get rid of all knob and tub wiring. Insurance company do not like to insurance homes when they find out it in your home. Since you have an existing...