Search results

Getting ready for my pressure test on my new sewer lateral and have to place a test plug in the old 4” cast iron drain coming out of the house. Problem is, I can’t get the plug to seal on the cast iron; the water level goes down very slpowlt but it does go down. I’ve elongated the possibility...

Hello, I’m in the process of completing my sewer lateral replacement and have a question about transition fittings. The new lateral is C900 dr 18 (city requirement bc of shallow depth of line) and the cleanout s are cast iron (another city requirement). Both plumbing supply houses that I...

Hello, I am planning to replace my current gas water heater with a 38,000 btu unit. I've noticed that the installation instructions as well as the building / plumbing code (I'm in California) require sufficient air for combustion. The water heater will be in a laundry room that is about...

I'm kind of embarrassed to ask this question, but how to I remove a T&P valve when there is not enough clearance between it and the gas hood to rotate valve? Thanks!

Due to its depth and the thickness of the americast material, it appears that the Americast Cambridge is designed to accept two drain and overflow assemblies, both made by American Standard. However, the reviews I've seen of those drains have been poor. Is there another drain and overflow...

Are there any toilets out there that will give me more clear space between the toilet and tub? Right now, if the stars align properly, I'll get 21" inches. I'd like to install a 32" wide tub, but that's going to further decrease my clear space, so I'm wondering if there is a toilet out there...

I've been reading this forum for a while and have found some really helpful advice and a vast amount of knowledge. Drawing on that advice, I have sketched out a design for the plumbing in my bathroom which is going to be remodeled shortly. The toilet and tub will be staying in the same...

Hello, I am in the process of adding a bathroom to an inlaw unit behind our house. The unit is about forty feet from the house sewer line. Best guess is the new bathroom will be about 1-2 ft below the bathroom of the house. I believe that I will have to install a sewage ejector pump in...

Hello, I am replacing a leaky main shut off valve to my house. I duplicating the exact set up that was there before except I am using brass valves / nipples instead of cast iron. The problem I am having is attaching the 3/4" brass shut off valve to the main water line coming from the city's...