Search results

I just removed the toilet in our bathroom so it could be cleaned underneath and then caulked as it was starting to stink. The floor is osb and the flange is attached to it. There is a sub floor of about 1/4" that isn't under the flange ( sub floor cut around flange installed after flange was...

I've got what I thought were american standard toilets (labels wore off) but the inside of the tank is stamped Briggs. I've got two cracked flush valve stems and need to replace. I took the tank off and noticed the tank to toilet gasket has two ears which the bolts that hold the tank to the...

The tank lid on my toto drake is not level with respect to the toilet. It tilts at an angle towards the bowl. If you look at the lid you can see it is casted at an angle which I assume is intentional. I installed my tank following the instructions and it is sitting properly on the three mount...

Sigh...I over tightened one of the bolts on my closet flange and broke the abs flange at the bolt mount (at least I didn't break the toilet). The flange is an inside flush mount flange that goes into a 4" ABS pipe mounted in a concrete floor. At this point I think I have two options. 1. Drill...

Does the Toto Drake toilet come with those plastic bolt covers to cover up the flange bolts or do I have to buy those? thanks, Brendin

Can someone recommend a good toilet that meets the following criteria. 1. installing in a basement on concrete slab (needs to push enough water so it won't back up) 2. at least 6 litres per flush (no ultra low flushers) 3. need to be able to buy it regular stock at stores like HD...

The builder roughed in our plumbing in the basement. The toilet pipe is a 4" abs pipe coming out of the concrete. It is sticking up about 1.5' above the floor. The problem is that the pipe is coming out at a slight angle. It wasn't too noticeable but if I put a level on it it is out of level...