Search results

I have a 1-1/4 tubular tailpiece coming from a new sink. I have a 1-1/2 sch 40 drain and was planning on converting immediately to 1-1/2 tubular with the tailpiece extender. However, I'm not sure if the reducing washer isn't fitting correctly? It is hand tightened as much as possible and it...

I was able to get everything in this main stack dry fitted perfectly, but then I started gluing all together from the top down which I realize was a bad choice since I now have no movement available to slip on the last 3" wye. How do I go about fixing this? I am ok cutting further down on the...

I am in MN which follows the 2020 UPC. I am splitting a 10x7 full bath into 2 smaller 5x7 baths (3/4 one side, full other side). To accomplish this the existing fixtures & drains will all have to be moved. There is an existing 1.25" vent which I'll be reusing (upping the size to 2") as well as...

Doing a kitchen remodel which involved removing the soffit for cabinets to the ceiling. All went well except it revealed the vent for kitchen (and also vents laundry room sink, floor drain, and washing machine below kitchen). I was hoping the vent would be covered in the top portion of a...