Either way you first diagramed it will work. No need to use a wye on the stack. If you don't have that much room underneath then bring the line up to the left of the toilet, put a heel outlet above the floor and turn the 90 on the toilet to the left.
It's only a nailer for the drywall, run a cup saw through it leaving as much as possible. How did you intend on turning this into a double vanity, you can put only 1 trap on a trap arm. You need to either cut in a san tee underneath, run over to within 42 inches of the other sink then revent or...
is this a residential toilet or a commercial toilet? Do you mean when you backed off the mounting nut the threaded rod came out with it? You should be able to screw it back in. There should have been a backup nut to lock it in place. Depending on the wall material there also should be an...
Where did the phrase (total dishcharge for stack)come from and how does it relate to a question on allowable fixture units on a 2 inch vent? According to the UPC 24 fixture units can run on a 2 inch vent with a maximum lenth of 120 ft, 40 of which can be horizontal.
keep the stem half closed. Tighten it by hand ensuring that the stem can spin freely until the bonnet is tight. Why not replace the hot and cold at the same time while the water is off? Do not apply any grease on the stem, have had them open by itself after using greaseon the stem (brass barrel...
Make sure the water is off and the stem is open (the bibb washer is not compressed against the seat.) This will not only make removal easier it wil also ensure you don't strip the threads in the valve body. Some valves like harcraft for example have fine soft threads and trying to remove the...
Turn off the water remove the cartridge and blow compressed air through the shower head and see if it is clear. This is the only fixture with a problem?