Recent content by Water Monster

Thank you, Gentleman. So, I found a qualified man with a trencher that can do this for me. He objects to the 1.5" poly due to his inability to handle the large roll. Any advice? It looks like Menards has something similar at 174 lbs. He says that it's hard to roll it out and tough to get it to...

Thank you, Valveman. That's what I wanted to here. Two more questions, please... 1. How difficult is it to roll out that 1.5" pipe? I understand it can get tangled and make a mess. 2. What are best fitting to use? I saw a video last night for Ford couplers and pack joints. Thank you very much...

Yes...I understand but don't know how to accurately measure it. It could be 20-30'.

Hi Valveman...it is uphill for 1000' and then mostly flat.

I'd like to thank everyone for help with this and comments. We have been using another solution as this is more of a hunting camp but need to get back to it. I can restate the problem with some new variables. 1" municipal tap at street with approximately 80 psi and 1500' to property. Will...

Does it matter which direction I go in with 2" pipe? Attach bell end to meter or other end to start?

Frost line is 5 - 18" here. How do I get from 2" PVC to this tee? Reducer? Splitter?

No, sorry...I'm running 2500' from highway up and along a dirt road to my property which is 1 square acre. We will have 4 RV sites on the property which we will terminate with frost proof hydrants. So 2500' of 2" PVC then split and reduce to 4 smaller runs at 100', 150', 200' and 225'.

Incoming pressure is 80 lbs...can you tell what is best way to split 2" PVC pipe at end of run? If we terminate at valve box in front of property then reduce and split to 1" or 3/4" PEX pipe or equivalent with 3 or 4 distribution points. Any pre-made adapters for this?

Ok...if we need to regulate pressure then with 2" pipe how is this best accomplished. Someone suggested that the regulator should go immediately after the tap at the street? Does this make sense? I thought that I would place regulator at the end of the 2500' run and before entrance to the...

I did not think of roots...plan to trench on Monday and up a dirt road and very close to tree line. Thought that I would keep the trench closer to the trees than the road? Road has mild traffic, maybe 25 cars a day, and most of trench would go in drainage ditch that is less than a foot deep in...

I'm a little concerned about the glue. This is the first I've heard about a gasket pipe. I planned to use ball valves periodically to isolate future problems or leaks. Could we accomplish the same thing with this...500' or 1000' of glued pipe and then a compression type ball valve? Could a...

Thank you, Valveman...I just noticed your post on the new page. What about primer/glue for the 2" PVC? This is what suppliers here are suggesting?

Thank you for the comments. One more question please... We plan to trench using a bobcat with rented attachment which I think will leave a ditch 5" - 6" wide. Is 2" pipe flexible enough for us to drop this in as we go along and lift the end out to glue on new piece? Any other thoughts or...

That's what I'm looking for...is this potable? Engineer suggests larger pipe for run over 1000' with 2"? If we split at end for 3 cabins/RV's and a hydrant is 1" ok? Will PVC manifold from Jaccuzzi supply work?