Recent content by Shinshi

I would like to install a utility sink in my basement and I am considering my options on how best to plumb it. The main stack is on the completely opposite side of the finished basement, so not an option. There is a drain in the basement floor, 6 feet from where I would like to locate the...

Yes, I will get back as to whether removing the auto shutoff valve completely cures the problem. It may be a while though, as it can work for weeks just fine and then act up. For the record, the auto shutoff valve was the first thing I replaced when this problem started. It happened the...

I will remove the auto shutoff valve and see if it makes a difference. I did have this problem prior to installing the Permeate pump, but I am willing to try anything because I have tried everything else I can possibly think of short of replacing the whole RO system with a new one. Any chance...

Here is a picture of my RO setup.

To clarify, I had this problem prior to installing the Permeate Pump. I installed the pump thinking it might correct the issue. I also replaced the Auto Shutoff Valve to no avail. I have not removed the Auto Shutoff Valve completely from the system as it is not recommended to do so when...

Does anybody have any idea at all? I have tried everything I can think of and this problem just doesn't make sense.

I have a RO system that stops producing water periodically. If I turn off the supply water for 20 minutes or so and then switch back on it clears itself and starts producing again. I changed all the filters, including the membrane, same problem. It gets worse in the cold winter weather, so...

I have ABS pipe in the wall with a cleanout and I'd like to install a flush cleanout cover like this one Watts makes... http://www.watts.com/pro/_productsFull.asp?catId=67&parCat=378&pid=1305&ref=2 Now Watts only offers this in Brass. I have searched the internet and this forum and I...

I don't know why the two drains weren't tied in together in the first place. The reason I was looking at using an elbow with a heel inlet was because I have another 3" pipe connection from above. I decided there were too many things I did not know and could not easily find out about plumbing...

OK. Thanks. Back to the drawing board...

I also need to divert the main stack on the basement wall. It is show in the first picture here. I need to move it over to run up to the other side of the beam. My plan is to cut it off and divert it with a joint like I have shown in the second pic. I don't see any problems doing this...

I am moving some DWV piping in the basement prior to developing. The main DWV pipe in this first picture needs to be moved to the other side of the main beam and connected to the sink drain shown in the second picture. The last picture is how I think the two should be connected...

I am trying to figure out the best way to make a basement floor cleanout to be as unobtrusive as possible. I would like to set it in the concrete and ensure that it will allow for a flush surface after the subfloor is installed. I am considering a Watts adjustable floor cleanout like a CO-200-R...

Thank you Redwood, for providing a link to that Watts cleanout. I really quite like that idea and I also found some that were good for recessing tile. I can use that style in the bathroom floor. I had done some searching for floor cleanouts, but not come across the one you linked to here...

Thank you for the advice. With the helpful feedback I have received, I am now convinced and will make these access points easily accessible. More so than I had originally planned. Now I will just have to come up with an ingenious way to build an access panel into my Delta FL & OSB subfloor that...