Recent content by Ordie

Here is the results of current arsenic test completed yesterday. Arsenic (III) 0.0035 mg Pass /Limit 0.001 0.010 mg/L EPA 200.8 JLR-NH 03/26/20 3:57PM Arsenic (V) (calc.) 0.0130 mg Fail /Limit 0.001 0.010 mg/L EPA 200.8 JLR-NH 03/26/20 3:57PM Arsenic*...

Here is a link to my Well Test from State of Maine: https://drive.google.com/file/d/1RFW-uw2fo6bxw8wm-YK0kP_q2DpSlv9T/view?usp=sharing

I installed a whole house activated alumina filter, but it drops the 65 psi water pressure to much. I am now looking at a GreenFlo LayneRT Upflow Arsenic 10 Filter System Will this filter allow better flow? Any thoughts on using this type filter?

^

Installing a whole house well system for 2 adults, containing a Big Blue 2 Stage Filter, FLECK Controlled Whole House Digital Water Softener System - 24K Grains, and UV Sterilizer. Maybe a sediment filter 1st? In which order should they be installed? Seperate the BIG BLUE filters, or keep...

Installing a whole house well system for 2 adults, containing a Big Blue 2 Stage Filter, FLECK Controlled Whole House Digital Water Softener System - 24K Grains, and UV Sterilizer. Maybe a sediment filter 1st? In which order should they be installed? Seperate the BIG BLUE filters, or keep...

Yes, Propane. Thanks Rob

Just bought a combustion analyzer, high and low fire were adjusted within factory specs, are these numbers looking good ? HTP UFT-80w installed new in August 2018 https://drive.google.com/file/d/1WElWf0Qtu0Xqa8-nrV5I9i3xEAYBAFWq/view?usp=sharing

That's exactly what i was planning to do, seal it in the house and leave the tank end open as it is. Thanks DANA

I like the conduit also, but was wondering if it should end above ground prior to entering house?

Concerned about propane copper gas line conduit (grey) entering house, if there is a gas leak in the line buried outside wouldn't the conduit allow the gas to come into house? In attached picture below is how the propane contractor installed the gas line...

Actually it came out easy, wasn't an issue.

Propane tank and line installed by local company, boiler has been commissioned and running for the last 5 days, still have some things to do but its been running good. See any issues? https://drive.google.com/file/d/1uyRd4Wt9tBlQdbMppQscLxYKWatauAOj/view?usp=sharing...

I would like that, can you break down the list, say A list is most common failure parts and B list nice to have but rarely fails? I planned on ordering spare parts, to keep down time during the winter to a minimum. Also I already swapped out the sensors and purged system of air all is good so...

Thanks for all the help Rob, couldn't figure out how to PM you or I would have? Looks like part number 7855P-364, will need 2 gaskets at 6 bucks each plus shipping,ouch.