Recent content by JRLND

6" to center of pipe (san-tee connection)

Ahhh crap.....luckily it's not a terrible fix to cut out and move that transition, but I think I'll leave it and see if he gives me a hard time. Counter top (flood rim) to bottom of san-tee pipe is 5"...my new vanity is 35" top of counter, which must have been taller than the old...I can't...

Thanks for all of the help. I sure hope this is legal. Here’s a pic

I see these are not ASTM D3212 certified, which the UPC calls out. I can't even find a flexible coupling that meets that.

Awesome. I have the final design done now, thanks. Only issue is splicing in to the main-vertical 3” vent/drain. I have wyes for it, but won’t be able to make the connections due to limited movement of pipe and all of the other connections. Can I use a rubber coupling? I bought 2. See...

Thanks for the help. It is greatly appreciated. The left needs a long turn, but the right lav just a combo? This is what I currently have. I will have to cut out and put a 2" pipe there...

This is what I came up with. Not sure if it’s code.

I am putting in 2 lavs now. To the right, the current single lav, 1.5” pipe, goes to a T on the main 3” vertical vent/drain

See attached photo. I am redoing the rough in for my sink plumbing. I currently have 1 lab and am switching to 2. I need help on how to properly set drains and vents to meet code.