hi,
I need help with the supply lines. if you look at the picture of the drail line i already installed you can see the blue tape and red tape at the existing 1/2 inch copper.
I tapped into the adjacent wall master bath vanity sinks...one of them.
I was thinking of cutting the 1/2 copper and then adding a compression Tee fitting then doing copper line with more 90 degree compression elbows to get where i need to go.
OR
is there a Tee out there somewhere, that i can Tee into the existing 1/2 copper sink lines and then thread in a long stainless steel flex or pvc line and go straight to the bottom of the sink handles?
oh, side note, do they have stud repair braces to repair the 5 stud bottoms i killed...lol.
-J
I need help with the supply lines. if you look at the picture of the drail line i already installed you can see the blue tape and red tape at the existing 1/2 inch copper.
I tapped into the adjacent wall master bath vanity sinks...one of them.
I was thinking of cutting the 1/2 copper and then adding a compression Tee fitting then doing copper line with more 90 degree compression elbows to get where i need to go.
OR
is there a Tee out there somewhere, that i can Tee into the existing 1/2 copper sink lines and then thread in a long stainless steel flex or pvc line and go straight to the bottom of the sink handles?
oh, side note, do they have stud repair braces to repair the 5 stud bottoms i killed...lol.
-J
Attachments
Last edited by a moderator: