Kohler Wall Diverter Sticks

Discussion in 'Shower & bathtub Forum & Blog' started by digits, Feb 25, 2008.

  1. digits

    digits New Member

    Messages:
    1
    We have a tub/shower with Kohler hardware that is probably 20 years old. It is a single handle model with the diverter mounted on the wall near the handle that controls the on/off and temperature of the water. My problem is that the diverter sticks and is very hard to push in or to pull out. If you grab it and push it in and out repeatedly, it will loosen up but after a short while it will stick again. I've tried lubricating it with WD-40 and petroleum jelly but it doesn't seem to last.

    Any suggestions on how I might get the diverter to operate smoothly again?

    Thanks.
Similar Threads: Kohler Wall
Forum Title Date
Shower & bathtub Forum & Blog Steel tub tear out / Kohler Villager install - Alcove - Block Wall Jun 7, 2013
Shower & bathtub Forum & Blog ***Kohler Shower Valve replacement ***HELP Yesterday at 6:41 AM
Shower & bathtub Forum & Blog Need help fixing a Kohler shower faucet Jun 20, 2014
Shower & bathtub Forum & Blog Installing a Kohler Acrylic Windward® tub, K-1113 60" x 42" Jun 15, 2014
Shower & bathtub Forum & Blog Drain shoe gasket will not seal on new Kohler acrylic tub Jun 8, 2014

Share This Page