Cyclonic heat question.

Discussion in 'HVAC Heating & Cooling' started by rockycmt, Nov 7, 2011.

  1. rockycmt

    rockycmt New Member

    Messages:
    129
    Location:
    New York
    I have a zone for my first floor that does a 3/4" run around the parimiter of the house and up to cast iron radiators via monofow tee. In this order: Bathroom, BR2, BR1(master), LR, DR and Kitchen. The first 2 points get real hot cuase they are early in the cycle. Sweat out the bedrooms when keping the thermostat (In living space) at 65deg. The other living spaces LR DR KIT are not as warm cause they are toward the end of the run. I want to better ballance the one zone. Was thinking of repiping with Pex from a manifold at the boiler. Am I on the right path with this? Is this a compn practice. My basement in unfinished so it should be an easy task. Any pointers?
Similar Threads: Cyclonic heat
Forum Title Date
HVAC Heating & Cooling Ductless heat pump question Today at 2:43 PM
HVAC Heating & Cooling Water heater vent Tuesday at 6:16 PM
HVAC Heating & Cooling Radiant Heating Loop Tweaking Nov 16, 2014
HVAC Heating & Cooling Connecting a new radiant heat zone for a garage slab to an existing baseboard boiler heating system Nov 12, 2014
HVAC Heating & Cooling terms in a hot water heating system and help needed on wiring Nov 6, 2014

Share This Page