jdf405
Electrical Engineer
My Rinnai R94LSe has two electrical connectors on the bottom, one is a ~1" diameter white threaded plastic connector for the remote, the other is a ~1/2" black rubber grommet - I assume for the 120VAC.
The black grommet will not provide any protection from the AC line pulling out and causing damage or shock. I though the hole in the chassis should be connected to with a 1/2" flex conduit, or at least a romex clamp to hold the cable tight. BUT its not a 1/2" connector - its just shy - I was unable to get a 1/2" connector in the hole.
How have you seen this done? Thanks for your advice!
The black grommet will not provide any protection from the AC line pulling out and causing damage or shock. I though the hole in the chassis should be connected to with a 1/2" flex conduit, or at least a romex clamp to hold the cable tight. BUT its not a 1/2" connector - its just shy - I was unable to get a 1/2" connector in the hole.
How have you seen this done? Thanks for your advice!