What I refer to as the 'main' is the shutoff that is outside the home, at the meter. Sorry if I did not use the correct terminology.
As for inside the home - there is only one shutoff, the branch that goes to my gas dryer. Yes, that would be my reasoning for a shutoff on the branch, to allow...
My home is 80 years old, and unfortunately the previous owners did not install a single shutoff aside from the main at the meter. I'm going to install a shutoff at the branch that goes off to the kitchen, and another right before the connection to the range. Is this not the best idea?
Okay, simple question.
I'm extending an existing gas line in my home for a gas range installation. I'm going to install a few new shutoffs and extend the line into the kitchen - my question is this: what's the best sealant to use on the pipes when I connect them together? Is teflon tape...
I'm installing a new lavatory in a fully gutted bathroom - I am able to take care of the drain and vent properly (thanks to many of you on this forum) but my question relates to the fittings for the P-trap. Everything is 1 1/2" ABS, so I am wondering which fitting I should use to connect the...
I'm installing a Toto Vespin toilet in a newly remodeled bathroom and am wondering where I should install the toilet flange and the unifit rough-in - should I attach the flange to the subfloor and therefore also the unifit rough-in to the subfloor, or should I install both over the tile floor...
Terry,
Based off of the link you gave me, I fit into the 1' per branch category.
would you then recommend 1" to supply the main branch, then each area (e.g. kitchens, bathrooms, laundry area) be reduced to 3/4", and then again to 1/2" for each fixture? or what way would you recommend?
Steve,
I can't speak for your situation, but due to the help with other people on this forum, I was pointed in the direction of using a sanitary tee with a side inlet to be able to do both. Granted, there can be no drains above this coupling on the stack, to allow these units to vent...
Same here - 80% of my house is knob and tube, and all on one single circuit. Home inspector missed it by a mile.
Which is why I'm in the process of a whole house rewire...
Well...I'm installing a new bathroom on the second floor and the house currently has 1/2" throughout - it's old and starting to get deposits in spots and causing problems with pressure.
Also, I looked at the main shutoff a little closer and saw that it's actually 1" coming into the house and...
The water line coming off of my main shutoff is 1/2" - am I able to increase the pipe to a larger size right after the main shutoff without losing much pressure?
Right - 2" is both code and is appropriate for everything that is being vented.
That's not my question - I am wondering if a 3" stack will work just as well as a 4" would for my scenario.
I know that I don't need any 15A circuits, my question was more along the lines of which rooms need to be on their own circuits for outlets, and should the light fixtures be on their own circuit separate from the outlets? Or is it easier just to wire each room's outlets and light fixtures on...
I recently purchased my 80 year old home and am beginning to remodel. During the process, I will be replacing most of the existing iron and old copper pipe with new copper supply pipe.
I've read that it's a good idea to supply the bathrooms that have both a toilet and a shower with 3/4"...