Recent content by amdskip

Hello All, I have ripped out an old bathroom that consisted of a tub/shower, sink, and toilet all in a row. The room adjacecent to all of this had a kitchen sink. This is the drain that is visable on the lefthand side of my picture. The new plans call for leaving the tub/shower in the same...

Thanks, I'll get some copper for that. My instructions are mostly pictures:(

Wanted to make sure this looked ok before I went sealing it up. Pictures There are a few pictures in there before that one if you use the arrows at the top to view them. Yes I am a messy plumber, practice makes perfect right:D

Both of my full baths currently vent to the attic and I plan on changing that. I have the vents to install them in the gable. My question is how the heck do I get up there to use a holesaw and vent them? My house is a 2 story and where I want to place them has my 1 story garage directly below...

Sounds good, looks like I need PRV. **** has them for around $25 shipped, Watts brand, would this work? Next comes a brass T to which I can screw in a pressure gauge. Next another shut off valve. Then convert back to CPVC. Then expansion tank. Any advice for this? My coworker has a...

A coworker who lives in the same neighborhood as me recently had his pipes replaced and the plumbers determined that his water pressure was registering over their 100 psi gauge. I am now wondering if my pressure is too high (I'm sure it is) and I would like to install a prv and I believe an...

Hi all, I'm in the middle of a bathroom remodeling project (everything getting replaced except the tub) and I want to replace the drains. The problem is getting to the connections to replace them. http://picasaweb.google.com/skippysg/HouseInProgress/photo#5160354166477381346 Various...