I know this must be a stupid question, but how sensitive are CPVC fittings to twisting motions? Today I disconnected my washer hoses. I tried to be as careful as possible, but I still twisted the shutoff valve slightly. Actually, the valve itself did not twist, the movement was in the CPVC pipe itself. I think it twisted in one of the 90 degree fittings. It was not a large twist, probably less than 1/4 turn.
What I am worried about is the seal in the fittings being compromised. I opened the access panel to check, and there was no water leakage, but I'm still a little worried.
This is a brand new pipe system.
Am I being overly sensitive? Are these fittings designed to handle a little bit of motion with no ill effect?
What I am worried about is the seal in the fittings being compromised. I opened the access panel to check, and there was no water leakage, but I'm still a little worried.
This is a brand new pipe system.
Am I being overly sensitive? Are these fittings designed to handle a little bit of motion with no ill effect?
Last edited by a moderator: