Toilet Rough In Problem(?)

Discussion in 'Toilet Forum discussions' started by leesburg_dave, Feb 2, 2006.

  1. leesburg_dave

    leesburg_dave New Member

    Joined:
    Feb 2, 2006
    Hello. I am installing a bathroom in the unfinished part of my basement. The builder installed rough-ins using 4" PVC for the W/C. The builder's floor plan, when looking at the fixtures is like this: Left wall, 48" vanity cabinet, W/C, tub/shower. The bathroom size is 112" wide and 60" deep. Center of this PVC to the new framing will be 12-1/2" (I think I'm OK there?) and the center of this pipe to the edge of the bathtub will be 17". So far so good. Here's my question: We bought a 48" wide vanity base cabinet and a 49" wide piece of granite for the top. The distance from the vanity base cabinet side to the center of the pipe is 15" (and that's taking into account the finished wall on the left side of the cabinet). However, when you place the granite vanity top in place, it hangs over 1" on the right side. Does this cause a code violation or do they measure from the vanity base cabinet side to the toilet? Thanks in advance.

    David
     
  2. hj

    hj Moderator & Master Plumber Staff Member

    Joined:
    Aug 31, 2004
    Occupation:
    Plumber
    Location:
    Cave Creek, Arizona
    15"

    They do not usually measure it. The look at it and if it looks like it is too close then they measure it. You should have no problem.
     
  3. Sponsor

    Sponsor Paid Advertisement

     
Similar Threads: Toilet Rough
Forum Title Date
Toilet Forum discussions found a leak through a hole in the toilet waste pipe Jun 25, 2016
Toilet Forum discussions Any round-bowl Toto toilets w/14" Unifit rough-in? Jun 9, 2016
Toilet Forum discussions Replacing a 1929 14" rough toilet Apr 13, 2016
Toilet Forum discussions 14-inch Rough-In. Standard hight like 14 to 14.5 inches what toilet? HELP! Mar 27, 2016
Toilet Forum discussions Antique toilet 14" rough in Mar 25, 2016

Share This Page